ERSA i-CON VARIO 2 HP multi-channel soldering station 250W

Scope of delivery
– Antistatic electronics station (0ICV203HP)
– i-Tool HighPower 250W (0240CDJ)
– Soldering tip, 12mm wide (0242CDLF120)
– Storage stand (0A57)

The i-CON VARIO 2 HP multi-channel soldering station comes standard with our most powerful soldering iron, the i-Tool HighPower (250W heating power). This soldering iron is ideal for tasks that require a lot of heat, such as soldering:
– Very thick cables
– Metal sheets
– Heavy transformers
– and anywhere where large metal surfaces need to be soldered extremely quickly

As usual, many tools from the i-Con Vario family can be used. The following tools are compatible:

– i-Tool HighPower (0240CDJ) included as standard
– i-Tool (0100CDJ)
– Chip-Tool Classic (0450MDJ)
– Chip-Tool Vario (0460MDJ)
– X-Tool Classic (0720EDJ) only with vacuum unit 0CU100
– X-Tool Vario (0740EDJ) only with vacuum unit 0CU100
– Micro-Tool (0270BDJ)
– Tech Tool (0640ADJ)
– Power Tool (0840CDJ)
(Attention! This station is optimized for the High Power Tool. It is not possible to operate an Air Tool with this station.)

As is customary in the i-CON family, the compact, ESD-safe supply unit offers the usual simple and clear operability. Interfaces to Ersa solder fume extractors and preheating plates are just as much a matter of course as with the larger i-CON VARIO 4, as is the simple and secure configuration of the station via a microSD memory card. The current firmware versions can be viewed and downloaded at any time at http://www.ersa.de/vario.

– Energy consumption in standby mode approx. 25W